The Daniel Defense V7 LW is five ounces lighter than the standard V7. It uses our Modular Float Rail (MFR) 12.0, providing each shooter with the ultimate in modular adaptability. Should the shooter desire, the tube can be run “slick” with an uninterrupted top rail that runs the length of the tube. In addition, the 3” Modular Picatinny Rail sections allow the shooter to customize the rail set up. The DDM4v7 is equipped with a single pinned low profile gas block that is drilled, taper reamed, and press fit into place to securely attach the low profile gas block to the barrel assembly. This rifle also comes with the newly designed, rugged and comfortable Daniel Defense Buttstock and Pistol Grip.
MATERIALS & CONSTRUCTION
- LOWER RECEIVER: Mil-Spec with Enhanced Flared Magazine Well and Rear Receiver QD Swivel Attachment Point. CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized
- UPPER RECEIVER: Mil-Spec with Indexing Marks and M4 Feed Ramps. CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized
- BARREL: Chrome Moly Vanadium Steel, Cold Hammer Forged, 1:7, 16″ Lightweight Profile, Mid-length Gas System, Chrome Lined, MP tested, and Mil-Spec Heavy Phosphate coated
- GAS SYSTEM: Pinned Low Profile Gas Block CNC Machined of 4140 hardened steel and Mil-Spec Heavy Phosphate Coating, Mid-length, Direct Impingement
- MUZZLE DEVICE: Daniel Defense Flash Suppressor, 17-4 PH Stainless Steel, Salt Bath Nitride Finished
- BOLT CARRIER GROUP: M16 Profile, Mil-Spec MP Tested, Chrome Lined, Properly Staked Gas Key
- BUFFER: H Buffer
- SIGHTS: Sold Separately
- HANDGUARD: Daniel Defense Modular Float Rail™ 12.0, CNC Machined of 6061-T6 Aluminum, with three Modular Picatinny Rail Sections, Type III Hard Coat Anodized
- RECEIVER EXTENSION: 6 Position Mil-Spec 7075-T6 Aluminum
- BUTTSTOCK: Daniel Defense Buttstock, Glass Filled Polymer with Soft Touch Overmolding
- PISTOL GRIP: Daniel Defense Pistol Grip, Glass Filled Polymer with Soft Touch Overmolding
- RAIL LADDERS: 3 low profile ladders made from Santoprene, heat resistant to 300° F.
- Made in the USA!
All Daniel Defense products carry a 100% satisfaction guarantee against defects in original materials and workmanship. If your Daniel Defense product shows evidence of such defects, Daniel Defense will make every accommodation to fix, repair, or replace your rail system in the most expeditious and inexpensive manner possible. Daniel Defense does not warranty products or damage caused to our products by the correct or incorrect installation of other manufacturer’s products. Be sure to retain your sales slip as proof of purchase date when making a claim.
|Manufacturing # / SKU||02-128-16524-047|
|Product Weight||6.29 lbs|
|Length||32 ¼” – 35 7/8”|
|Magazine||Magpul PMAG 30-Round|
|Case||Daniel Defense Full-Latch Impact Plastic Case|