Developed over a decade ago by our friend Ashley Burnsed when he determined that the the CAR-15 should have a sling attachment point at the rear of the receiver in a position similar to the loop found on the MP5-A3. The first Burnsed Loop was an old QD Sling Swivel which Burnsed sliced and welded onto a receiver end plate then hand polished with a file to eliminate any burs or rough edges which could abraid the weapon sling. Daniel Defense faithfully carries on the spirit of that original design by paying attention to the little details that others deem insignificant.
- Fully radiused edges, inside and out to prevent fraying of your sling or your hands
- A properly positioned loop: High enough to allow proper manipulation of the safety and yet low enough to keep the meat on your knuckles when performing high speed drills
- 1.25" Diameter
Materials & Construction
Precision CNC machined from Aircraft Grade 6061-T6 Aluminum and Military Specification Type III Hardcoat Anodized black for a rock hard lasting finish while weighing in at a mere .4 ozs.
- Aircraft Grade 6061-T6 Aluminum
- Military Specification Hard Coat Anodizing
- Weighs only 0.4 ozs!
- Made in the USA!
Installation requires removal and re-installation of your existing collapsible stock and buffer tube. A spanner wrench is the only tool necessary to perform this task.
All Daniel Defense small part accessories carry a 100% satisfaction guarantee against defects in original materials and workmanship. If your Daniel Defense small part accessory shows evidence of such defects, Daniel Defense will make every accommodation to fix, repair, or replace your part in the most expeditious and inexpensive manner possible. Daniel Defense does not warranty products or damage caused to our products by the correct or incorrect installation of other manufacturer’s products. Be sure to retain your sales slip as proof of purchase date when making a claim.
|Manufacturing # / SKU||Carbine_Burnsed_Loop|